NIOSHTIC-2 Publications Search

Task-specific postures in low-seam underground coal mining.

Moore SM; Pollard JP; Nelson ME
Int J Ind Ergon 2012 Mar; 42(2):241-248
The objective of this study was to determine low-seam mine worker exposure to various postures as they pertain to job classifications and job tasks. Sixty-four mine workers from four low-seam coal mines participated. The mine workers reported the tasks they were required to complete and the two postures they used most frequently to perform them. They were provided with a schematic of postures from which to select. The two postures reported most frequently were identified for each task along with the job classification of the workers performing the tasks. Of the 18 tasks reported, over two thirds were performed by at least two different job classifications and over one third were performed by four or more job classifications. Across tasks, the postures used appeared to vary greatly. However, when grouped by job classification, the most frequently reported posture across all job classifications was kneeling near full flexion. Operating the continuous miner was associated with frequent squatting and was likely used because it affords great mobility, allowing operators to move quickly to avoid hazards. However, for environments with a restricted vertical height such as low-seam mining, the authors recommend squatting be avoided as data demonstrates that large amounts of femoral rollback and high muscle activity for the extensors when performing lateral lifts in this posture. Kneeling near full flexion was reported as the most frequently used posture by all job classifications and was likely due to the fact that it requires the least amount of muscle activity to maintain and has reduced pressures at the knee. However, the authors recommend this posture be avoided when performing lateral lifting tasks. Like squatting, kneeling near full flexion results in increased femoral rollback and may increase the stresses applied to the meniscus. Unlike lateral lifting, maintaining a static posture results in knee loading and muscle activity such that the mine worker should consider kneeling near full flexion and sitting on their heels. Although kneeling near full flexion is associated with injuries, there are benefits to this posture that are realized when statically kneeling (minimal muscle activity, allows worker to maintain an upright torso in low heights, and decreased loading at the knee). However, cartilage is avascular and nourished by synovial fluid. Therefore, one should frequently rotate between postures, assuming a more upright kneeling posture when possible and frequently fully flexing and extending the knee allowing nutrients to the cartilage.
Mining-industry; Underground-mining; Coal-mining; Ergonomics; Mine-workers; Miners; Underground-miners; Posture; Musculoskeletal-system; Injury-prevention; Musculoskeletal-system-disorders; Knee-injuries; Knee-disorders; Author Keywords: Knee; Kneeling; Crawling; Posture; Mining; Coal
Susan M. Moore, 626 Cochrans Mill Road, PO Box 18070, Pittsburgh, PA 15236, United States
Publication Date
Document Type
Journal Article
Email Address
Fiscal Year
Identifying No.
Issue of Publication
NIOSH Division
Source Name
International Journal of Industrial Ergonomics
Page last reviewed: March 25, 2022
Content source: National Institute for Occupational Safety and Health Education and Information Division