NIOSHTIC-2 Publications Search

Load capacity and stiffness characteristics of screen materials used for surface control in underground coal mines.

Dolinar DR
Proceedings of the 25th International Conference on Ground Control in Mining, August 1-3, 2006, Morgantown, West Virginia. Peng SS, Mark C, Finfinger GL, Tadolini S, Khair AW, Heasley KA, Luo Y, eds. Morgantown, WV: West Virginia University, 2006 Aug; :152-158
Screen material in the form of welded wire mesh and geogrids are used in underground coal mines to prevent the fall of small pieces of rock from the roof between roof bolts. Further, if the screen is installed during the production cycle, roof fall injuries can be reduced significantly. Therefore, the National Institute for Occupational Safety and Health (NIOSH), because of the safety implications, conducted an evaluation of screen materials commonly used in U.S. coal mines to determine their support characteristics and identify the parameters that could affect their performance with respect to controlling the fall of rock from the roof surface. To evaluate the load and stiffness characteristics of the screen, a test frame was designed and installed in the Mine Roof Simulator (MRS) at the NIOSH Pittsburgh Research Laboratory (PRL). With this test set up, the screen is bolted at four corners of the frame and a center load is applied. The test set up allows for up to 20 in of screen deflection while the load and screen defection are continuously recorded. A series of tests were conducted to evaluate the effects of various parameters such as bolt tension, the type of load bearing surface and the size of bearing plates on welded screen performance. The most common screen material used in U. S. coal mines is an 8-gauge wire welded in a 4-by-4-in spacing or aperture. The peak screen load was normally limited by wire breakage. The conditions at the bearing plate influence the nature of the wire breakage. However, the screen stiffness was controlled by slippage at the bearing plates, and by weld and wire failure. The size of the bearing plate had a significant effect on the performance of the welded screen. Therefore, the design capacity of the 8-gauge screen is evaluated based on plate size. For a 6-by-6-in bearing plate the average peak load is 2,900 lb with a stiffness of 250 lb/in. For an 8-by-8-in bearing plate, the average peak load is 4,500 lb with a stiffness of 430 lb/in. These test results are based on a 4-by-4-ft bolt spacing. A geogrid mesh was also tested.
Surface-mining; Coal-mining; Coal-miners; Miners; Mining-industry; Underground-miners; Underground-mining; Rock-bursts; Rock-falls; Rock-mechanics; Safety-measures
Publication Date
Document Type
Conference/Symposia Proceedings
Peng SS; Mark C; Finfinger GL; Tadolini SC; Khair AW; Heasley KA; Luo Y
Fiscal Year
NIOSH Division
Priority Area
Disease and Injury: Traumatic Injuries
Source Name
Proceedings of the 25th International Conference on Ground Control in Mining, August 1-3, 2006, Morgantown, WV
Page last reviewed: September 2, 2020
Content source: National Institute for Occupational Safety and Health Education and Information Division