NIOSHTIC-2 Publications Search

Calibration of the Analysis of Longwall PIllar Stability (ALPS) chain pillar design methodology for Australian conditions.

Colwell M; Firth RC; Mark C
Proceedings of the 18th International Conference on Ground Control in Mining, August 2-5, 1999, Morgantown, West Virginia. Peng SS, Mark C, eds., Morgantown, WV: West Virginia University, 1999 Aug; :282-290
This paper summarizes the results of a research project whose goal was to provide the Australian coal industry with a chain pillar design methodology readily usable by colliery staff: The project was primarily funded by the Australian Coal Association Research Program and further supported by several Australian longwall operations. The starting point or basis of the project was the Analysis of Longwall Pillar Stability (ALPS) methodology. ALPS was chosen because of its operational focus; it uses tailgate performance as the determining chain pillar design criterion rather than simply pillar stability. Furthermore, ALPS recognizes that several geotechnical and design factors, including (but not limited to) chain pillar stability, affect that performance. There are some geotechnical and mine layout differences between United States and Australian coalfields that required investigation and, therefore, calibration before the full benefits offered by the ALPS methodology could be realized in Australia. Ultimately, case history data were collected from 19longwall mines representing approximately 60% of all Australian longwall operations. In addition, six monitoring sites incorporated an array of hydraulic stress cells to measure the change in vertical stress throughout the various phases of the longwall extraction cycle. The sites also incorporated extensometers to monitor roof and rib performance in response to the retreating longwall face. The study found strong relationships between the tailgate stability factor, the Coal Mine Roof Rating, and the installed level of primary support. The final outcome of the project is a chain pillar design methodology called Analysis of Longwall Tailgate Serviceability (ALTS). Guidelines for using ALTS are provided.
Mining-industry; Mine-workers; Miners; Accident-analysis; Accident-prevention; Control-technology; Safety-practices; Safety-research; Longwall-mining; Ground-control; Ground-stability; Statistical-analysis; Mining-equipment; Mining-industry; Underground-miners; Underground-mining
Publication Date
Document Type
Conference/Symposia Proceedings
Peng-SS; Mark-C
Fiscal Year
NIOSH Division
Source Name
Proceedings of the 18th International Conference on Ground Control in Mining, August 2-5, 1999, Morgantown, West Virginia
Page last reviewed: September 2, 2020
Content source: National Institute for Occupational Safety and Health Education and Information Division