NIOSHTIC-2 Publications Search
Noise abatement of pneumatic rock drill.
Pittsburgh, PA: U.S. Department of the Interior, Bureau of Mines, RI 7998, 1974 Dec; :1-45
In response to the Coal Mine Health and Safety Act of 1969, mandatory noise standards have been developed that specify time- noise limits of mine personnel exposure. Most affected by elevated noise levels is the pneumatic roof bolter operator, both in terms of levels near or in excess of 115 dba and in terms of length of exposure. Therefore, the principal emphasis of this Bureau of Mines report is on pneumatic drill noise control. It is not the intent of this report to suggest any drill redesign; instead, methods are suggested to reduce the noise level by complementing existing machines. An integral muffler system and a separate muffler system were tested in an attempt to lower pneumatic drill noise levels. Pneumatic drills, when new, operate at about 115 dba when drilling in sandstone. Using the drill muffler systems, it was possible to decrease the noise level of a 115-dba stope drill to approximately 100 dba.
Mining-industry; Mining-equipment; Noise; Noise-exposure; Noise-levels; Noise-sources; Power-tools; Pneumatic-tools; Pneumatic-equipment; Engineering-controls; Control-technology
IH; Report of Investigations
NTIS Accession No.
Pittsburgh, PA: U.S. Department of the Interior, Bureau of Mines, RI 7998
Page last reviewed: September 2, 2020
Content source: National Institute for Occupational Safety and Health Education and Information Division