Mining Publication: Methane Emissions and Airflow Patterns on a Longwall Face: Potential Influences from Longwall Gob Permeability Distributions on a Bleederless Longwall Panel

Original creation date: February 2018

Authors: S Schatzel, R Krog, H Dougherty

Peer Reviewed Journal Article - February 2018

NIOSHTIC2 Number: 20054555

Trans Soc Min Metall Explor 2018 Feb; 342:51-61

Longwall face ventilation is an important component of the overall coal mine ventilation system. Increased production rates due to higher-capacity mining equipment tend to also increase methane emission rates from the coal face, which must be diluted by the face ventilation. Increases in panel length, with some mines exceeding 6,100 m (20,000 ft), and panel width provide additional challenges to face ventilation designs.

To assess the effectiveness of current face ventilation practices at a study site, a face monitoring study with continuous monitoring of methane concentrations and automated recording of longwall shearer activity was combined with a tracer gas test on a longwall face. The study was conducted at a U.S. longwall mine operating in a thick, bituminous coal seam and using a U-type, bleederless ventilation system. Multiple gob gas ventholes were located near the longwall face. These boreholes had some unusual design concepts, including a system of manifolds to modify borehole vacuum and flow and completion depths close to the horizon of the mined coalbed that enabled direct communication with the mine atmosphere. The mine operator also had the capacity to inject nitrogen into the longwall gob, which occurred during the monitoring study. The results show that emission rates on the longwall face showed a very limited increase in methane concentrations from headgate to tailgate despite the occurrence of methane delays during monitoring.

Average face air velocities were 3.03 m/s (596 fpm) at shield 57 and 2.20 m/s (433 fpm) at shield 165. The time required for the sulfur hexafluoride (SF6) peak to occur at each monitoring location has been interpreted as being representative of the movement of the tracer slug. The rate of movement of the slug was much slower in reaching the first monitoring location at shield 57 compared with the other face locations. This lower rate of movement, compared with the main face ventilation, is thought to be the product of a flow path within and behind the shields that is moving in the general direction of the headgate to the tailgate. Barometric pressure variations were pronounced over the course of the study and varied on a diurnal basis.

First page of Methane Emissions and Airflow Patterns on a Longwall Face: Potential Influences from Longwall Gob Permeability Distributions on a Bleederless Longwall Panel
Peer Reviewed Journal Article - February 2018

NIOSHTIC2 Number: 20054555

Trans Soc Min Metall Explor 2018 Feb; 342:51-61


Page last reviewed: March 27, 2019
Page last updated: March 27, 2019