NIOSH Mining Safety and Health Topic

EAMP List of Figures


Contents
**EAMP Home
**Foreword
**Abstract
**Executive Summary
**Introduction
**Background
**Methods
**Results & Discussion
**Summary
**References
**List of Figures
**List of Tables
**Appendix A
**Appendix B
Figure 1: Emission measurement flowchart (63 KB)
Figure 2: Engine lug curve (57 KB)
Figure 3: Torque converter cross section (33 KB)
Figure 4: Preparing to perform the EAMP (27 KB)
Figure 5: Performing the EAMP (36 KB)
Figure 6: Laboratory apparatus (59 KB)
Figure 7: Relationship between nonvolatile DPM and equivalence ratio (49 KB)
Figure 8: Relationship between CO and nonvolatile DPM at high load (45 KB)
Figure 9: Relationship between CO2 and equivalence ratio (53 KB)
Figure 10: Relationship between CO and CO2 at high load by NDIR (47 KB)
Figure 11: Ecom-AC portable gas analyzer (115 KB)
Figure 12: Ecom-E hand-held gas analyzer (33 KB)
Figure 13: Ecom-AC and Ecom-E CO2 vs. NDIR CO (53 KB)
Figure 14: Ecom-AC and Ecom-E CO vs. NDIR CO (58 KB)
Figure 15: Ecom-AC NOx vs. CLS NOx (41 KB)
Figure 16: Relationship between CO and CO2 at high load by Ecom-AC (48 KB)
Figure 17: Relationship between CO and CO2 at high load by Ecom-E (47 KB)
Figure 18: DDEC reader (26 KB)
Figure 19: Use of photo-tachometer to verify engine operation at full load (18 KB)
Figure 20: DDC series 50 performance chart and lug curve (46 KB)
Figure 21: Effect of turbocharger lag on CO and CO2 emissions (53 KB)
Figure 22: Ecom-AC gas analyzer and laptop PC underground (24 KB)
Figure 23: Erratic emissions during hydrostatic drive stall (53 KB)
Figure 24: CO emissions from right and left banks of Deutz F6L413FW engine (42 KB)
Figure 25: CO2 emissions from right and left banks of Deutz F6L413FW engine (41 KB)
Figure 26: NO and CO2 emissions from two Deutz F4L912W engines (44 KB)
Figure 27: CO emissions from two Deutz F4L912W engines (33 KB)
Figure 28: Comparison of NO from different engine configurations (68 KB)
Figure 29: Comparison of CO from different engine configurations (51 KB)

Page last updated: October 21, 2008
Page last reviewed: June 20, 2008
Content Source: National Institute for Occupational Safety and Health (NIOSH) Mining Division